30 days ago, I made a post about the pin-hole camera I built as part of my first “solargraphy” photo attempt.
As stated in that post, the exposure started on Sunday, February 15th, 2015 at 9:42 AM Eastern.
Today, Tuesday, March 17th, 2015 at 10:42 AM Eastern, the exposure was stopped.
The shutter was open for exactly 2,592,000 seconds.
On March 3rd, 2015, Metro Detroit was hit with a snow/sleet/rain storm dumping 3 inches of snow in the morning, followed by sleet/rain in the afternoon. One of the big things I was worried about was what would happen if the can got wet.
Well, it got wet from the freezing rain, which resulted in the can getting covered in a sheet of ice!
I ended up placing my thumb over the pinhole for a couple seconds which started to melt the ice around the area and expose the hole. I wasn’t sure if water entered the can through the pinhole, but there was no way to find out until I cut the can open to retrieve the photo paper to scan it. From what I could tell, no water appeared to have entered through the pinhole.
This specific solargraphy photo captured 10.87 degrees of solar elevation angle change over the 30 day period.
When the sun was at it’s highest point in the sky on February 15th, 2015, the solar elevation angle was 34.71 degrees.
When the sun was at it’s highest point in the sky on March 16th, 2015, the solar elevation angle was 45.58 degrees.
Because the exposure ended at 10:42 AM Eastern on March 17th, 2015, the change in solar elevation angle needed to be calculated up to the last day that the sun was able to reach it’s highest point in the sky, which was the day before on March 16th, 2015.
The solar elevation angle calculations above are taken from the latitude and longitude coordinates of where the pin-hole camera was placed in my back yard.
For clarification, the solar elevation angle is the angle between the horizon and the center of the sun.
Imagine a gigantic protractor (hopefully you know what a protractor is) being placed on the ground and a string extending down from the sun to the middle point of the protractor. That is a “real life” example of how you would measure the solar elevation angle. I used an online solar elevation calculator though since there really is no way to use a protractor.
Below is the result of the 2,592,000 second exposure.
You can faintly see the house across the street as well as the tree that is in front of that house.
You can also see where the sun was when I started the exposure on Sunday, February 15th, 2015 at 9:42 AM Eastern.
The two white squares at the top of the photo is the black tape that I used to tape the photo paper to the inside of the bottom of the can so it wouldn’t move. I wasn’t able to remove it because it would rip the photo paper.
The dark blob at the bottom of the photo is actually the disc of black construction paper that I placed at the top of the inside of the can so the light wouldn’t reflect off of it. It ended up overlapping onto the photo paper just a tad, thus, not exposing that area.
All in all, I think the photo turned out great, and I look forward to building more of these cameras and placing them in random locations around Metro Detroit.